Rhinestone Application Instructions

Step 1
Place the Rhinestone Template Material (flock side up) on the cutting mat and cut out the design. Remove from the mat and pull the Rhinestone Template Material away from the protective backing to remove the circles from the holes. Place the Rhinestone Template Material on a Teflon sheet or parchment paper (or left over protective sheet from Peel ’N Stick) and place it in a tray or box.

Step 2
Pour rhinestones over the Template Material.

Step 3
Brush the rhinestones into the opening. A circular motion works best to set the rhinestones in the holes, right side up.

Step 4
Brush the excess rhinestones away from the Template Material.

Remove the protective paper from the Rhinestone Transfer Tape and place it over the rhinestones. Finger press the sheet to adhere the stones to the tape.

Step 6
Peel the tape off, lifting the rhinestones in formation from the tray.

Step 7
Turn on your iron or heat press. Place the rhinestones on the fabric and press for 25 seconds, 350 degrees.